Search This Supplers Products:PCB manufacturerPCB AssemblyCarbon PCBCeramic PCBFPC AssemblyElectronic Component
How to clean Printed Circuit Boards
time2012/02/07
Computers and other printed circuit board on the dust and dirt, easy to cause a short circuit, a device can not work properly. Cleaning dirt layer circuit board, is a simple way is to plot attacks dirt and dust, and may cause problems.
Explain
1 Turn the power off and turn on your computer or other electronic devices in the case. Check the battery of any printed circuit board, and remove them. If you have a battery in the circuit board, it usually is flat, disc-type battery, like the use of the watch. The battery can be gently pulled or forced open.
2. Blown off with compressed air may be printed circuit board any dust and debris. You can use an air compressor, compressed air (see Additional Resources)
3. Accumulated dirt can be resolved, the exchange of cotton dipped in rubbing alcohol and gently rub in the dirt. When you do, be careful not to expel any electronic components.
4 printed circuit board must be kept dry and no water, alcohol can be replaced if there is dry and replace the gear cover.
Explain
1 Turn the power off and turn on your computer or other electronic devices in the case. Check the battery of any printed circuit board, and remove them. If you have a battery in the circuit board, it usually is flat, disc-type battery, like the use of the watch. The battery can be gently pulled or forced open.
2. Blown off with compressed air may be printed circuit board any dust and debris. You can use an air compressor, compressed air (see Additional Resources)
3. Accumulated dirt can be resolved, the exchange of cotton dipped in rubbing alcohol and gently rub in the dirt. When you do, be careful not to expel any electronic components.
4 printed circuit board must be kept dry and no water, alcohol can be replaced if there is dry and replace the gear cover.